17
SEA FURY - EP
Item code: BH126
.
Instruction Manual
Rudder
pushrod.
Plastic parts of pushrod.
Cut.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape to
hold the foam in place.
3. Position the battery pack and receiver
is as pictures below
C/A glue
Do not permanently secure the receiver and
battery until after balancing the model.
4) Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
Bottom side.
E l e v a t o r
pushrod
Rudder
pushrod.
INSTALLING THE RECEIVER AND BATTERY.
Tie wrap.
Receiver
