PITTS
Item code: BH85-A
Instruction Manual
6
Repeat the procedure to install the other aileron
linkages in the other wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Using pliers, carefully make a 90 degree bend down at
the mark made. Cut off the excess wire, leaving about
6mm beyond the blend.
Flaslink
Pushrod wire
Control horn
Repeat the procedure to install the opposite wing
half
.
See pictures below:
See pictures below:
II. INSTALLING THE ENGINE MOUNT
OPTION 1: ELECTRIC MOTOR
There are two options:
1. Electric motor
2. Engine mount.
Drill a hole
5.2mm diameter
Cut.
4x70mm
4x30mm
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
