PITTS
Item code: BH85-A
Instruction Manual
13
2
) Assemble and mounting the wheel pants as
shown in the following pictures.
Repeat the procedure to install the opposite
gear.
1)
Set the tail wheel assembly in place on the
plywood plate. The pivot point of the tail wheel
wire should be even with the rudder hinge line
and the tail wheel bracket should be centered on
the plywood plate.
VIII. MOUNTING THE TAIL WHEEL
BRACKET
Aluminium landing gear
Collar.
M5 nut.
Flat washer.
3 x 12mm
2)
Mark the locations of the two mounting screws.
Remove the tail wheel bracket and drill 2mm pilot holes
at the locations marked.
3)
Secure the tail wheel bracket in place using
three 3mm x 12mm wood screws. Be careful not to
overtighten the screws.
Drill a hole
2mm diameter
Secure
Mark point
Silicone Tube
