10. INSTALLING THE TAIL WHEEL
- - 2
- -
3mm Colar
3x15mm Screw
- - - 2
- 2
- - - -
1.
Using the knife cut away the wood from the
bottom of the rudder and slide the two nylon clasps
into the slot. Using
the nylon clasps
as shown.
A+B Epoxy glue
2.
Set the tail wheel assembly in place on the
plywood plate.
Mark the locations of the two mounting
screws.
3.
Remove the tail wheel bracket and drill 2.5mm pilot
holes at the locations marked.
4.
Secure the tail wheel bracket in place using two 3mm x 15mm screw.
5.
Align the tail wheel wire so that the wire is parallel with the bottom of the rudder.
Secure
3x15mm
Mark
Fuselage
side
Bottom
A+B Epoxy glue
18
Instruction manual
PIPER J-3 CUB Item code: BH58A
