1)
Using pliers, carefully make a 90 degree bend down
at the mark made. Cut off the excess wire, leaving
about 6mm beyond the blend.
2)
Insert the 90 degree bend down through the hole in
the servo arm. Install one nylon snap keeper over the
wire to secure it to the arm. Install the servo arm
retaining screw.
ELEVATOR CONTROL
AND PUSHROD INSTALLATION
HORN
Control horn and linkages for Elevator are installed the
same way as the ailerons before (see page 5).
Bottom side.
A+B Epoxy glue
Drill a hole
1.5 mm
Silicone Tube
Elevator pushrod
Horn
Flaslink
Pushrod wire
servo arm
Flaslink
Elevator pushrod
9. RUDDER INSTALLATION
Hinges for Rudder are glued the same way as the
aileron before (see page 4)
.
1000mm Push rod
- 1
M2
- - - 1
2mm Nut
- 1
- - - - - -
Horn
- - - - - - - - 1
- - - - - - 1
Flaslink
Silicone Tube
Horn
Cut
Silicone tube
5mm
16
Instruction manual
PIPER J-3 CUB Item code: BH58A
