INSTRUCTION MANUAL
P-47 Thunderbolt
Item code: BH117
51
1)
We highly recommend setting up a plane using
the control throws listed.
2)
The control throws should be measured at the
widest point of each control surface.
3)
Check to be sure the control surfaces move in the
correct directions.
CONTROL THROWS
Aileron:
Elevator:
Rudder:
14mm up
12mm up
25mm right
28mm down for take off
60mm down for landing
25mm left
14mm down
12mm down
20mm up
18mm up
45mm right 45mm left
20mm down
18mm down
Flap:
Low rate:
14mm
Aileron control
14mm
12mm
12mm
Elevator
25mm
25mm
Rudder control
28mm
Flap
Aileron:
Elevator:
Rudder:
Flap:
High rate:
PRE-FLIGHT CHECK
1)
Completely charge your transmitter and
receiver batteries before your first day of flying.
2)
Check every bolt and every glue joint in your
plane to ensure that everything is tight and well
bonded.
3)
Double check the balance of the airplane.
4)
Check the control surface.
5)
Check the receiver antenna. It should be fully
extended and not coiled up inside the fuselage.
6)
Properly balance the propeller.
In order to obtain the CG specified, reposition
the receiver and other equipment.
If not obtain the CG specified, add a weight and
adjust.
Do not fly before confirming the
correct location of the CG. If the
CG is incorrect, you lose control
of your airplane which leads to
accidents.
Bottom View
CG
Summary of Contents for P-47 THUNDERBOLT BH117
