21
MUSTANG P51 -
Item code: BH33
.
Instruction Manual
5) When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your measure-
ments one more time before the epoxy cures.
Remove any excess epoxy using a paper
towel and rubbing alcohol and hold the stabi-
lizer in place with T-pins or masking tape.
6. After the epoxy has fully cured, re-
move the masking tape or T-pins used to
hold the stabilizer in place and carefully in-
spect the glue joints. Use more epoxy to fill
in any gaps that may exits that were not
filled previously and clean up the excess us-
ing a paper towel and rubbing alcohol.
Epoxy glue
C/A glue
C/A glue
Elevator control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Control horn of elevator (1set).
Remove covering
Nilon control
clasp
.
M3 lock nut.
3mm x 40mm.
ELEVATOR CONTROL HORN INSTALLA-
TION.
