Black Horse Model JU87-STUKA, Instruction Manual Book

Page: 28 / 34

JU87-STUKA -
Item code: BH80
.
Instruction Manual
28
1. Cut out the switch hole using a
modeling knife. Use a 2mm drill bit and drill
out the two mounting holes through the fuse-
lage side.
2. Secure the switch in place using the
two machine screws provided with the radio
system.
INSTALLING THE SWITCH.
1. Plug the servo leads and the switch
lead into the receiver. You may want to
plug an aileron extension into the receiver
to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from vi-
bration. Use a rubber band or masking tape
to hold the foam in place.
3. Position the battery pack and receiver
behind the fuel tank. Use two tie wraps to
hold the battery and receiver securely in place.
As pictures below.
Do not permanently secure the receiver
and battery until after balancing the model.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver,
for the antenna to exit.
INSTALLING THE RECEIVER AND BATTERY.
switch
Tie wrap.
Tie wrap for battery.
Battery