Black Horse Model JU87-STUKA, Instruction Manual Book

Page: 24 / 34

JU87-STUKA -
Item code: BH80
.
Instruction Manual
24
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
Epoxy glue
C/A glue
Also carefully remove the covering from
the horizontal fin as below the lines which
you drew as same picture below.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
Remove covering.
3. Mark the shape of the vertical on the left
and right side on the rudder using a felt-tip
pen.
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Mark line
Hingle slot
Epoxy glue