Focke-Wulf FW190A-
Item code:BH87
INSTRUCTION MANUAL.
34
1) We highly recommend setting up a
plane using the control throws listed.
2) The control throws should be meas-
ured at the widest point of each control sur-
face.
3) Check to be sure the control surfaces
move in the correct directions.
Flap : 20mm down.
Ailerons : 15mm up 15mm down.
Elevator : 15mm up 15mm down.
Rudder : 20mm right 20mm left.
1) Completely charge your transmitter and
receiver batteries before your first day of fly-
ing.
2) Check every bolt and every glue joint in
your plane to ensure that everything is tight
and well bonded.
3) Double check the balance of the
airplane.
4) Check the control surface.
5) Check the receiver antenna . It should
be fully extended and not coiled up inside the
fuselage.
6) Properly balance the propeller.
We wish you many safe and enjoyable
flights with your Focke-Wulf FW190A.
Lift the model. If the tail drops when you
lift, the model is “tail heavy” and you must add
weigh* to the nose. If the nose drops, it is “nose
heavy” and you must add weight* to the tail to
balance.
*If possible, first attempt to balance the model
by changing the position of the receiver bat-
tery and receiver. If you are unable to obtain
good balance by doing so, then it will be nec-
essary to add weight to the nose or tail to
achieve the proper balance point.
PRE-FLIGHT CHECK.
15
15
20
15
15
15
15
20
20
Flap control
Aileron control
CONTROL THROWS.
135
