Instruction manual FIESELER Fi156C STORCH Item code: BH99
4.
Using the thread as a guide and using masking
tape, tape the servo lead to the end of the thread:
carefully pull the thread out. When you have pulled
the servo lead out, remove the masking tape and
the servo lead from the thread.
5.
Place the servo into the servo tray/ hatch into the
servo box on the bottom of the wing and drill 1.5mm
pilot holes through the tray and servo box for each
of the four mounting screws. Secure the servo tray
in place using the mounting screws provided.
6
. Repeat step # 2 - # 5 to install the aileron servo in
the opposite wing half.
INSTALLING THE AILERONS AND FLAPS SERVOS.
1.
Install the rubber grommets and brass eyelets
onto the aileron servos.
2.
Using a modeling knife, remove the covering from
over the pre-cut servo arm exit hole on the aileron
servo tray / hatch. This hole will allow the servo arm to
pass through when installing the aileron pushrods.
3.
Place the servo into the servo tray. Center the
servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four
mounting screws provided with the servo.
8
For Flap servo.
For Aileron servo.
Bottom view
Aileron
Flaps
Bottom view
L
R
2x10mm Tp Screw
8
2
2x10mm Tp Screw
- - - - 32
- - - - 4
- - - - 4
- - - - 4
- - - - 8
- - - - 4
- - - - 8
3x12mm Cap Screw
3mm Hex Nut
3mm Flat
Washer
Ball link
2.6x120mm Push rod
Pinned Hinge
- - - - - - - 8
3x12mm Tp Screw
- - - - 16
- - - - 4
3x12mm Tp Screw
