29
CHIPMUNK
-Item code BH44.
INSTRUCTION MANUAL.
Ailerons : 15mm up 15mm down
Flap: 25mm down
Elevator : 15mm up 15mm down
Rudder : 35mm right 35mm left
1. We highly recommend setting up a plane
using the control throws listed.
2. The control throws should be measured
at the widest point of each control surface.
3. Check to be sure the control surfaces
move in the correct directions.
1. Completely charge your transmitter and
receiver batteries before your first day of fly-
ing.
2. Check every bolt and every glue joint in
your plane to ensure that everything is tight
and well bonded.
3. Double check the balance of the
airplane.
4. Check the control surface.
5. Check the receiver antenna . It should
be fully extended and not coiled up inside the
fuselage.
6. Properly balance the propeller.
We wish you enjoy.
PRE-FLIGHT CHECK.
With the wing attached to the fuselage, all
parts of the model installed ( ready to fly), and
empty fuel tanks, hold the model at the
marked balance point with the stabilizer level.
Lift the model. If the tail drops when you
lift, the model is “tail heavy” and you must add
weigh* to the nose. If the nose drops, it is “nose
heavy” and you must add weight* to the tail to
balance.
*If possible, first attempt to balance the model
by changing the position of the receiver bat-
tery and receiver. If you are unable to obtain
good balance by doing so, then it will be nec-
essary to add weight to the nose or tail to
achieve the proper balance point.
CONTROL THROWS.
15mm
15mm
15mm
15mm
35mm
35mm
25mm
