P47-THUNDERBOLT
.
Item code: BH36-A.
Instruction Manual
5
4)
Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Drill a hole
1.5mm
2x10mm
Secure
5)
Repeat the procedure to install the aileron servos
in the opposite wing half.
3. INSTALLING THE AILERON CONTROL HORN
1)
Remove the covering from the slot on the bot-
tom of the aileron.
2)
Insert the control horn into the slot and secure
it by A+B Epoxy glue.
2. INSTALLING THE AILERON SERVOS
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
3)
Using the thread as a guide and using
masking tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you have
pulled the servo lead out, remove the masking tape and
the servo lead from the thread.
Drill a hole
1.5mm
Servo tray
Remove the covering
Secure
Electric wire
Electric wire
1. A+B Epoxy glue
2. Push in
Aileron
control horn
