Black Horse Model BH172, Instruction Manual Book

Page: 26 / 41

PIPER PA -18 SUPER CUB Item code: BH172 I nstruction manual
INSTALLING THE SWITCH
1) The switch should be mounted on the fuselage side, opposite
the muffler, close enough to the receiver so the lead will reach. Use
the face plate of the switch cut out and locate the mounting holes.
2) Cut out the switch hole using a modeling knife. Use a 2mm drill
bit and drill out the two mounting holes through the fuselage side.
3) Secure the switch in place using the two machine screws
provided with the radio system.
1) Plug the servo leads and the
switch lead into the receiver. You
may want to plug an aileron
extension into the receiver to make
plugging in the aileron servo lead
easier when you are installing the
wing. Plug the battery pack lead
into the switch.
2) Wrap the receiver and battery
pack in the protective foam to
protect them from vibration. Use a
rubber band or masking tape to
hold the foam in place.
Do not permanently secure the
receiver and battery until after
balancing the model.
INSTALLING THE SWITCH, RECEIVER AND BATTERY
Receiver
26
TOW PLANE
M3
3mm Nut
8mm Nut
Tow plane
108mm Push rod
- 1
- - 1 3mm Nut
M3 - - 1
- - - 1
Tow plane