PROCTOR Item code: BH154
.
Instruction Manual
6
Repeat the procedure to install the second aileron
linkages in the opposite wing half
.
After both linkages are completed. connect both of
the aileron servo loads using a Y-harness you have
purchased.
Insert the 90 degree bend down through the hole in the
control horn. Install one nylon snap keeper over the
wire to secure it to the control horn. Install the control
horn retaining screw and remove the masking tape
from the aileron.
II. INSTALLING THE FLAP
Flap install as same as the way of aileron. Repeat
step #1 - #4 on the part I (page 4,5) to install the flap.
Flaslink
Pushrod wire Control horn
Bend and cut.
Silicone Tube
III. INSTALLING ELECTRIC GEAR
RETRACTS
PARTS REQUIRED
Electric not included.
73.5mm
28mm
21mm
44mm
Only including oleo struts.
5x30mm
3x15mm
(Electric Not Included.)
5x30mm
Secure
