ARROW 3D Instruction Manual.
8
5) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
Repeat the procedure for the other
servo
.
INSTALLING ELEVATOR.
Right side
Left side
C/A glue
Center line
1) Using a modeling knife, remove the
covering at fuselage slot.
Remove covering
2) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the
trailing edge and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
3) Slide the the horizontal fin without el-
evator into place in the pre-cut slot in the rear
of the fuselage.
Mark line
Top
