DIABLO Instruction Manual.
1 3
5) When you are sure that everything is
aligned correctly, mix up a generous amount
of Flash 30 Minute Epoxy. Apply a thin layer to
the top and bottom of the vertical fin mounting
platform sides in the fuselage. Slide the vertical
fin in place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the vertical fin in place with
T-pins or masking tape and remove any
excess epoxy using a paper towel and rubbing
alcohol.
CONTROL HORN INSTALLATION.
Control horns as same as method of aileron
wing. See pictures below:
2 x 16 mm.
INSTALLING RUDDER.
1) Using a modeling knife, remove the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage. This
slot accepts the lower rudder hinge.
Remove covering.
Hinge.
3) When you are sure that everything is
aligned correctly, mix up a generous amount
of Flash 30 Minute Epoxy. Apply a thin layer to
the top and bottom of the vertical fin mounting
platform sides in the fuselage. Slide the vertical
fin in place and realign. Double check all of
your measurements once more before the
epoxy cures. Hold the vertical fin in place with
T-pins or masking tape and remove any
excess epoxy using a paper towel and rubbing
alcohol.
2) Slide the vertical fin into place in the
pre-cut slot in the rear of the fuselage.
Attach C/A glue into hinge.
