DIABLO Instruction Manual.
1 2
1) Using a ruler and a pen, locate the
centerline of the horizontal stabilizer, at the
trailing edge and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge of
the stabilizer.
2) Slide the the elevator into place in the
pre-cut slot in the rear of the fuselage.
INSTALLING ELEVATOR.
3) Using a modeling knife, remove the
covering at servo tray and at fuselage slot.
Remove covering.
4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
Hinges.
Remove covering.
