13
SU 26M-EP -
Item code: BH97
.
Instruction Manual
1) Using a modeling knife, remove the
covering from the top of the fuselage and the
covering from over the precut hinge slot cut
into the lower rear portion of the fuselage This
slot accepts the lower vertical.
3. Mark the shape of the vertical on the
left and right side of the rudder on to the hori-
zontal stabilizer using a felt-tip pen.
2. Put the rudder into the fuselage as
same as picture below.
Hinge slot
Mark line
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Also carefully remove the covering from
the horizontal fin as below the lines which
you drew as same picture below.
R e m o v e
covering
Epoxy glue.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
5. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
