5
P-40C TOMAHAWK.
4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
2) Using a modeling knife, remove the cov-
ering at possition show below.
C/A glue
C/A glue
C/A glue
R e m o v e
covering.
Summary of Contents for BH56
