31
P-40C TOMAHAWK.
Install adjustable servo connector in the
servo arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to the
bottom nut. This will prevent the connector from
loosening during flight.
Servo arm.
Connector.
PUSHROD THROTTLE SERVO
INSTALLATION.
Secure
1) Cut out the switch hole using a modeling
knife. Use a 2mm drill bit and drill out the two
mounting holes through the fuselage side.
2) Secure the switch in place using the
two machine screws provided with the radio
system.
INSTALLING THE SWITCH.
Remove covering
Throttle servo
Summary of Contents for BH56
