4
YAK 55 -
ITEM CODE:BH111.
Instruction Manual
1. Install the rubber grommets and brass
eyelets onto the aileron servo.
REPLACEMENT SMALL PARTS
1. Aluminium landing gear(Right &Left).
3. Spinner.
2. Wheels.
4. Fuel Tank.
2) Using a modeling knife, remove the cov-
ering at possition show below.
3) Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
4) Drill 1,6mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo.
6. Tail gear set.
5.Engine mount ply of wood .
INSTALLING THE AILERON SERVOS.
3x12mm
3x15mm
3x12mm
Aileron
Bottom side
Electric
wire
Thread
