List of tools needed for assembly:
• Needle nose pliers • Scissors • Hammer or crowbar • Straight screwdriver
• (2) 13mm wrenches • (2) 17mm wrenches • (2) 19mm wrenches
Two (2) people may be required for assembly.
1. Cut and remove banding using scissors.
2. Cut and remove sides and top of crate using hammer or crowbar,
then take all parts out of the crate.
3. Attach tire
B
to the tank axle using flat washer, castle nut and cotter pin
C
,
D
,
E
.
Install the hub cap
F
on the end using hub cap tool and rubber hammer (see arrow).
4. Attach the tongue
G
to the tank using hex bolt, flat washer and lock nut
H
,
I
,
J
.
5. Connect the beam
K
and tank assembly using hitch pin and R-Clip
L
,
M
.
Put the engine
N
on the mounting plate, tighten with hex bolt, flat washer, lock washer
and nylon lock nut
O
,
P
,
Q
,
R
.
6.
Attach the suction line tube
S
to the bottom of the gear pump and secure with clamp
T
.
Put the O ring
U
on the gear pump connector
V
, then attach the hydraulic hose
(valve-gear pump)
W
to the gear pump connector
V
.
9. Put the O ring
X
on the oil filter connector
Y
, then attach the hydraulic hose
(valve-oil filter)
Z
to the oil filter connector
Y
.
!
CAUTION
Item Description
Qty.
1 Tire
2
2 Flat Washer, Ø20
2
3 Castle nut, M20 x 1.5
2
4 Cotter pin, Ø4 x 36
2
5 Hub Cap
2
6
Tongue
1
7 Hex Bolt, M12 x 100mm, G8.8
2
8 Flat Washer, Ø12
2
9 Nylon Lock Nut, M12
2
10 Beam
1
11 Hitch Pin
1
12 R-Clip
1
13 Engine
1
14 Hex Bolt, M8 x 40mm, G8.8
4
15 Flat Washer, Ø8
4
• (1) Adjustable wrench
18
19
7.
8.
16 Lock Washer, Ø8
4
17 Nylon Lock Nut, M8
4
18 Suction Line Tube
1
19 Hose Clamp
1
20 O Ring, Ø11 x 2.5 (27-Ton)
O Ring, Ø14 x 2.5 (32-Ton)
1
21 Gear Pump Connector
1
22 Hydraulic Hose (valve-gear pump)
1
23 O Ring, Ø17 x 2.5
1
24 Oil Filter Connector
1
Hydraulic Hose (valve-oil filter)
25
1
11
UNPACKING & ASSEMBLY
8
7
6
13
14
15
9
11
10
12
16
17
18
19
21
20
22
23
25
24
3
5
4
2
1
