background image

4

5

• Use in a dry location only.

• Except for the bulb, there are no user-serviceable parts inside. Do not attempt to disassemble any other parts 

of the unit.

• To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting.

• Do not attempt to charge the unit if the 120 volt AC charger plug is damaged – return the unit to manufacturer 

for repair.

SAVE THESE INSTRUCTIONS

INTRODUCTION

Thank you for choosing the 

Black & Decker

®

 Rechargeable Spotlight. 

Please read this guide carefully 

before use to ensure optimum performance and to avoid damage to the unit.

FEATURES

ON/OFF TRIGGER

RUBBER BEZEL

LED AREA LIGHTS

AREA LIGHT

ON/OFF BUTTON

BUILT-IN 120 VOLT AC 

CHARGER (BACK OF UNIT)

BATTERY STATUS LED 

INDICATOR

TRIGGER LOCK

QUARTZ HALOGEN BULB

EASY GRIP HANDLE

PISTOL GRIP HANDLE

CHARGING/RECHARGING THE LIGHT

This unit is shipped in a partially charged state. Charge unit after purchase and BEFORE first use using 

the 120 volt AC charger until the green Battery Status LED Indicator LED lights (approximately 10 

hours). Charge after each use.
IMPORTANT: When the unit is not in use, we recommend that the battery is charged at least every 30 

days.

CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE: 

• Never place the light face down on any surface when charging.

• Failure to keep the battery charged will cause permanent damage and result in poor performance.

Charging/Recharging Using the 120 Volt AC Charger and a Standard Household 

Extension Cord (not included)

BUILT-IN 120V AC 

CHARGER

BATTERY STATUS LED 

INDICATORS

HOUSEHOLD EXTENSION CORD 

(NOT INCLUDED)

• Make sure the Spotlight is OFF (the Trigger Lock is in the OFF position and the Trigger is not depressed). 

• Lift the AC charger cover located at the back of the unit and connect a standard North American 120 volt AC 

extension cord to the 120 Volt AC Charger. Plug the other end of the cord into a standard 120-volt AC wall 

outlet.

• Charge for one additional hour after the green Charge Status LED Indicator lights (approximately 10 hours). 

OPERATING INSTRUCTIONS

Operating the Spotlight

TRIGGER

TRIGGER LOCK

  1. Disconnect from charger.

  2. The ON/OFF trigger is located in the front of the pistol-grip handle of the spotlight.

  3. To turn the spotlight ON, squeeze the trigger. 

  4. To turn OFF the spotlight, release the trigger. 

Note: 

The ON/OFF trigger can be locked in the ON position using the trigger lock ON switch on the side of the unit.  

Operating the LED Area Lights

The ON/OFF pushbutton for the LED Area Lights is located on the top of the Spotlight.
IMPORTANT: The Battery Status LED Indicators will not light when the spotlight is turned on. The Battery 

Status LED Indicators will light when the LED Area Lights are operated. (When all three battery status LEDs 

light, it indicates a full battery. Only one red battery status indicator light indicates that the unit needs to be 

recharged.)

CARE AND MAINTENANCE

All batteries lose charge with time, especially when they are warm. Recharge the unit every 30 days 

when not in frequent use, preferably using the 120 volt AC method.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the spotlight unit with a 

soft cloth moistened with a mild solution of water and detergent.
The quartz halogen bulb is the only user-replaceable part in the Spotlight. Periodically inspect the condition of 

cords, connectors and wires. Contact Technical Support toll-free at 1-877-571-2391 to replace any components 

that have become worn or broken. 

Spotlight Bulb Replacement

IMPORTANT: Before proceeding with bulb replacement, check the filament to determine if the bulb needs 

to be replaced.
To replace the bulb, you will need a small Phillips screwdriver and a 6 volt H3 75 watt replacement bulb. During 

installation, avoid touching the glass part of the bulb. Bulb life may be shortened by installing a bulb with dirt or 

fingerprints on it. The bulb can be wiped clean with a cloth moistened with alcohol.

RETAINING RING

RUBBER  

“O” RING

REFLECTOR

RUBBER  

END CAP

RUBBER BEZEL COVER

TRIGGER 

(OFF) LOCK

TRIGGER  

SWITCH

QUARTZ HALOGEN 

BULB

VEC157BD_VEC157BDC_ManualENSP_012216.indd   4-5

1/22/2016   10:47:58 AM

Summary of Contents for 1,000,000 POWER SERIES









Reviews: