Black+Decker WV1450, Original Instructions Manual

Page: 6 / 24

6
ENGLISH
(Original instructions)
Features
This Appliance includes some or all of the following features.
1. Motor unit
2. Handle
3. On/Off button
4. Power cord rewind button
5. Suction port
6. Blower port
7. Container
8. Latch
9. Wheels
10. Hose
11. Hose Handle
12. Tube
13. Upholstery attachment
14. Floor head
15. Crevice nozzle
16. Dust bag
17. HEPA filter
18. HEPA filter cover
Assembly
Install the wheels
Attention ! If any part is missing or damaged, please do not
assemble until you have all the parts.
Invert drum to install wheel .
Insert the four wheels (9) into the socket of drum bottom.
Be sure that wheels spin freely.(figure1)
Assembling the device
1. Fitting the HEPA filter. Put the HEPA filter (17) into float
holder, then lid the HEPA filter cover (18), fasten it
clockwise. On the contrary, remove the HEPA filter
anticlockwise. (figure2)
Note: HEPA filter---High Efficiency Particulate Air Filter
When picking up small amounts of liquid the HEPA filter
may be left in place.
When picking up large amounts of liquid we recommend
that the HEPA filter be removed .If the HEPA filter is not
removed, it will become saturated and misting may
appear in the exhaust.
2. Fitting the dust bag. Put the dustbag board (16) into inlet
base.(Dustbag board should aim at the slot of the inlet
base). Rotate the board clockwise 90 degrees to fasten
the dustbag according to arrow direction(LOCK side)
(figure3). To remove the dustbag from the inlet base, just
rotate the dustbag board anticlockwise 90 degree(OPEN
side),then take out the dustbag.
Note:The dust bag use only for dry-vacuum can not be
used for wet suction
3. Install the power head assembly onto the drum assembly
as shown. (figure4)
4. Rotate both latches down and press until you hear them
snap over the flanges on the drum. (figure5)
5. Insert the flexile hose connector into the inlet base of the
vacuum cleaner. (figure6)
Operation
Accessories use instructions:
The vacuum is equipped with three nozzles for different
applications. Each individual nozzle can either be fitted onto
the connecting tube or directly onto the handle of the flexible
hose.
1. Floor brush
This is suitable for cleaning wide areas. The floor brush is
fitted with a practical 360
0
tie-in, this ensures that you can
reach easily into any corner. (figure7)
PUSH DOWN
Figure 1
Figure 2
Figure3
Figure 4 Figure 5 Figure 6