6
7
SNEAK-A-CUP
TM
FEATURE
Remove the carafe and brewing is paused. The carafe must be placed back on
the carafe plate in 30 seconds to prevent overflow. Brewing begins again.
SETTING AUTO BREW TIME
1.
Press PROG button. The AUTO light (small dot in bottom left corner of digital
display) flashes several times. Digital clock displays 12:00.
2. Quickly press HOUR button then MIN button to select the time you would like
automatic brewing to begin (for example, 7:15 A.M. Make sure the P.M. light is
not on.)
3. Press AUTO button, holding it down until the AUTO light stops flashing.
The digital display changes to time of day.
4. To check preset auto time, press PROG button and preset auto time is displayed.
Press AUTO button to reactivate the timer. The AUTO light will turn on.
5. To cancel Auto Brew function, press the AUTO button. The AUTO light will turn off.
CARE AND CLEANING
This product contains no user serviceable parts. Refer service to qualified
service personnel.
CLEANING
Make sure your coffeemaker is unplugged and cool.
1.
Remove brew basket. Discard used paper filter and coffee grounds.
2. Wash brew basket and carafe in dishwasher (top-rack) or by hand in hot,
soapy water.
3. Wipe outside of coffeemaker, control panel and carafe plate with a soft,
damp cloth.
Note:
Do not use abrasive cleansers or scouring pads. Never immerse the
coffeemaker in water.
4. To clean the inside of the cover, open the cover and leave in the open position;
wipe with a damp cloth.
COFFEEMAKER PART
CLEANING INSTRUCTIONS
Housing
Carafe Plate
Power Cord
Wipe with a soft, damp cloth.
Carafe Lid
Brew Basket
Glass Carafe
Wash by hand in warm soapy water, or in the
dishwasher (top rack only).
CLEANING WITH VINEGAR
Note:
With regular use, minerals and hard water can clog your coffeemaker.
A full cleaning with vinegar is recommended once a month.
1.
Pour white vinegar into water reservoir up to the 6-cup mark on the water
window. Add cold water up to the 12-cup mark.
2. Put a paper filter in brew basket and close cover. Set empty carafe on the carafe plate.
3. Turn on coffeemaker. Let half the cleaning mixture brew into carafe (until level
is around 5). Turn off coffeemaker and let it soak for at least 15 minutes
4. Turn on coffeemaker again and brew remaining cleaning mixture into carafe.
Turn off coffeemaker; empty carafe and discard paper filter.
5. Fill reservoir with cold water to 12-cup mark; replace carafe on carafe plate and
then turn on coffeemaker for a complete brewing cycle to flush out remaining
cleaning mixture. You may want to repeat this step to completely remove the
vinegar smell/taste.
6. Wash brew basket and carafe as instructed in CLEANING.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Coffeemaker does
not turn on.
Coffeemaker is not plugged in. Make sure appliance is
plugged into a working
outlet.
Coffeemaker
is leaking.
Water reservoir may be
overfilled.
Make sure water reservoir
has not been filled
beyond the 12-cup line.
Cover may not be correctly
placed on carafe.
Make sure cover is
correctly placed and
tightened on carafe
Carafe may not be correctly
placed on the carafe plate.
Make sure carafe is
placed securely onto
the carafe plate.
The brew basket
overflows.
The carafe has been removed
for longer than 30 seconds
when using the Sneak-A-
Cup™ feature.
Make sure to replace
the carafe within 30
seconds during the
brewing cycle.
Excessive amount of coffee
is used.
Reduce the amount of
coffee used.
Coffee sediment in
brewed cup of coffee.
The paper filter and/or the
brew basket are not properly
placed.
Insert basket-shaped
paper filter into brew
basket and insert basket
properly into holder.
The coffeemaker
brews slowly.
The coffeemaker needs
cleaning.
Follow the instructions
in the “Cleaning with
Vinegar” section.
If additional assistance is needed, please contact our consumer service team at
1-800-465-6070.