WATER DRAINAGE
Draining in Cooling Mode.
This air conditioner is equipped with auto water evaporation so the water
compartment would not typically fill in cooling mode unless there is high
humidity. Water drainage will generally only be required at the end of the season
(see START-END OF SEASON OPERATIONS in cooling mode.)
NOTE:
As a safety measure to positively prevent water spillage the air
conditioner is equipped with a fail safe device if the water tank fills. The
unit will completely stop, the control panel displays
(FULL TANK). The
compressor and fan will not restart until the tank has been drained.
Intermittent Draining in Cooling Mode.
• Unplug the unit from the power source. Carefully move the unit to a drain area
over your basement floor or drip pan (not included). Remove the bottom drain
cap.
• Let the water drain away and replace the drain
cap. Restart the machine until
the symbol
disappears. If the error repeats, call for service.
NOTE
: Be sure to reinstall the bottom drain plug before using the unit.
Continuous Draining for Cooling Mode
• Unplug the unit from the power source. Remove the bottom drain cap. While
doing this operation some residual water may spill so have a drip pan (not
supplied) to collect the water.
• Connect the drain hose (supplied) as shown in the diagram. The water can be
continuously drained through the hose into a floor drain or drip tray.
Turn on the unit.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
• After the unit has stopped, it cannot be restarted for 3 minutes. Operation will
automatically restart after 3 minutes.
SET UP & USE
Page 25
ENGLISH
