5
o
CONTROL PANEL
Note: If the food processor does not
run, make sure the workbowl and lid are
properly locked and on the base.
OFF
Press OFF to stop the food processor when
it is running on LOW or HIGH.
LOW
When LOW is selected, the processor will
run at a low speed until OFF is pressed.
HIGH
When HIGH is selected, the processor will
run at a high speed until OFF is pressed.
PULSE
Use PULSE for short processing tasks using
the chopping blade. This lets you control
the size and uniformity of foods being
chopped.
• The PULSE button must be pressed and
held for the appliance to operate in PULSE
mode. When released, the appliance will
stop.
• Press the button and then release to allow
the blade to stop running and the food to
fall to the bottom of the workbowl.
USING THE CHOPPING
BLADE
The chopping blade is used to coarsely or
finely chop, mince, mix, and puree.
Caution: The chopping blade is very sharp.
Use caution when handling and storing.
1. Assemble the food processor with the
center shaft and chopping blade in the
workbowl.
2. Place food in workbowl.
3. Place cover on workbowl and lock into
place by rotating clockwise.
4. Put the food pusher in place.
Important: Never use your fingers to direct
food through the feed chute.
5. Select your desired speed (LOW, HIGH, or
PULSE).
Note: Process foods for no more than a
few seconds at a time. Pulsing produces
excellent results and offers greater control.
6. When finished, press OFF.
Important: Make sure the chopping blade
has completely stopped before removing
the cover or workbowl from the processor.
7. Twist cover counterclockwise to remove.
8. Lift workbowl off base.
