7
®
Using the rear mounting slot
The slot at the rear of each module allows it to be hung upon a fixed screw that
protrudes from the mounting surface.
IMPORTANT: The internal circuit board is accessible through the mounting slot.
Ensure that any mounting screws protrudes no further than 1⁄2” (12.5mm) into
the module casing - serious electrical damage will be caused if the screw makes
contact with the internal circuitry.
5mm (
)
0.19"
9.5mm
0.37"
(
)
Using the self adhesive feet
Apply the supplied self-
adhesive rubber feet to the
underside corners of the
Wizard modules.
Mounting
Before you begin connecting to the source PC system and display devices, it
is advisable to mount the Wizard modules in place. There are a number of
mounting possibilities for the transmitter and receiver modules:
• On a horizontal surface using the supplied self adhesive feet,
• Mounted on a screw using the rear slot,
• Within the
,
• On inclined surfaces using self adhesive Velcro
©
strips (not supplied).
