9
®
Making standard connections
Connections to the Wizard modules do not need to follow the precise order
given in this user guide although it is recommended that you do not apply
power to the modules until all other connections have been made.
Note: Unless stated otherwise, all connection information given here applies to
all modules in the Wizard AVU family.
Connections at the transmitter
To connect video and audio from the source PC system
1 Attach a video cable of suitable type and length (fully shielded with 15 way
male D-type connectors at both ends, 6 feet or less) to the socket labelled
IN
on the Wizard transmitter.
2 Attach the other end of the video cable to the appropriate VGA
video output socket on the source PC system.
3 Attach a stereo audio cable (shielded with three way
3.5mm jack plugs at both ends) to the socket
labelled
IN
on the Wizard transmitter.
4 Attach the other end of the stereo audio
cable to the appropriate audio
output socket on the source PC
system.
To connect a monitor and speakers
The video and audio out ports of the Wizard transmitter can optionally be used
either to:
• Attach a monitor and/or speakers in the vicinity of the source PC system
– See below,
or
• Make a cascade link to another transmitter module – Please refer to the
section
Making cascade connections – Cascading transmitters
.
1 Attach the video cable from the monitor to the socket labelled
OUT
on the Wizard transmitter.
2 Attach the stereo audio cable from the speakers to the
socket labelled
OUT
on the Wizard transmitter.
