Installing the VOE
24
VOE102 Getting Started Guide
3 • VOE installation
connect to an Ethernet hub or switch. Typically the hub or switch will connect to a router that provides the the
local-residential IP network with broadband Internet access.
Figure 7. Connecting the VOE to the network via a hub or switch
1. Using the included black Ethernet cable, connect the RJ-45 Ethernet WAN port on your VOE (labeled
ETH), to an Ethernet hub or switch on the same network as your PC.
For details on the Ethernet port pinout and cables, refer to
Appendix B, “Cabling”
on page 40 and
Appendix
C, “Port pin-outs”
on page 43.
Connecting the VOE to the power supply
1. Insert the barrel-type connector end of the AC power supply into the 5V DC, 1.0A port (see
figure 2
on
page 16).
2. Verify that the AC power cord included with your router is compatible with local standards.
3. Connect the male end of the AC power supply power cord to an appropriate AC power outlet.
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
Ethernet Hub
or Switch
PC
DHCP
Server
LAN
ISDN 2
ISDN 1
VOE102
ETH
port
CAUTION