SERVTRAY
12
5. Remove both of the loosely connected rear brackets and slide the console drawer out halfway to balance
its weight. (See Figure 3-5.) The front brackets are now supporting the console drawer.
Figure 3-5. Front brackets support the console drawer.
6. Using four screws (included), attach the module to the rack. Then slide the extensions (from the Rear
Bracket Extension Kit) into both KVM module sides. Attach either the short or long extensions
(depending on your kit), as shown in Figure 3-6.
Figure 3-6. Attaching the extensions to the KVM module.
7. The rear brackets, extensions, and slide rails fit tightly. Make sure you follow these steps carefully for easy
installation.
a) Slide the rear brackets onto the extensions.
Rear bracket
removed
Console drawer
Vertical rail
Vertical rail
Rear
bracket
removed
Attaching the short
extensions
Unit may appear different
based on ordering
options
Unit may appear different
based on ordering
options
Unit may appear
different based on
ordering options
Attaching the long
extensions
Install the top of the
plastic extension’s wider
side near the ServTray.
Summary of Contents for ServTray KVT415A
Page 3: ......
