14
Power Switch Cabinet 4-port New Generation
3.3.3. General / SNMP
The Power Switch PSE544 provides a built-in SNMP (Simple Network Management Protocol) agent, which enables
you to manage the Power Switch PSE544 through SNMP-based network management systems. The Power Switch
PSE544 MIB file enables to remotely read out the status of all power outlets and the values of all sensors
(temperature, humidity, ambient light). It also enables to control individually all power outlets and all groups of
power outlets. The MIB file is stored on the Power Switch PSE544 and can be downloaded from the General /
Tools Page.
SNMP enabled:
Check this box if you want to enable the SNMP protocol.
Contact:
In this field, enter the name you want to give to the Contact field. The name can be from 1 to 64 characters long,
and can contain alphanumeric characters. Default name is "contact".
Name:
In this field, enter the name you want to give to the Name field. The name can be from 1 to 64 characters long, and
can contain alphanumeric characters. Default name is "name".
Location:
In this field, enter the name you want to give to the Location field. The name can be from 1 to 64 characters long,
and can contain alphanumeric characters. Default name is "location".
Read Community:
In this field, enter the name you want to give to the Read Community field. The name can be from 1 to 64
characters long, and can contain alphanumeric characters. Default name is "public".
Write Community:
Check this box if you want to be able to control the power outlets through a MIB browser. In the following field,
enter the name you want to give to the Write Community. The name can be from 1 to 64 characters long, and can
contain alphanumeric characters. Default name is "private".
Trap Community:
Check this box if you want to configure the Power Switch PSE544 SNMP agent to send traps to a community. In
the following field, enter the name you want to give to the Trap Community. The name can be from 1 to 64
characters long, and can contain alphanumeric characters. Default name is "trap".
Trap Destination 1:
Check this box and enter the primary SNMP Server address the traps will be sent to.
Trap Destination 2:
Check this box and enter the secondary SNMP Server address the traps will be sent to.
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.
