5
CHAPTER 1: Safety instructions
5
1. Safety instructions
To be read before use!
•
The Office/Cabinet Power Switch devices can only be installed
by qualified people with the following installation and use
instructions. The manufacturer disclaims all responsibility in
case of a bad utilisation of the Office/Cabinet Power Switch
devices and particularly any use with equipments that may cause
personal injury or material damage.
•
This equipment is designed to be installed on a dedicated circuit
that must have a circuit breaker or fuse protection.
•
The electrical power socket used to plug the power cord of the
Office/Cabinet Power Switch device must be close to the
Office/Cabinet Power Switch device and easily accessible.
•
Check that the power cords, plugs and sockets are in good
condition.
•
The Office/Cabinet Power Switch devices can only be connected
to three-wire 230 VAC (50-60Hz) sockets.
•
Always plug the Office/Cabinet Power Switch devices into
properly grounded power sockets (two poles plus ground).
•
Never exceed 10 Amp total load.
•
If you have to replace an external fuse of an Office/Cabinet
Power Switch device, never use another type of fuse than
10A/250V T.
