15
CHAPTER 3: Installation and Configuration
3. Installation and Configuration
Each SFOM-HS2 has a three-position loop-activation
switch on the front panel, plus ten internal DIP
switches (see
Figure 3-1
below). Use these switches
to configure the SFOM-HS2 prior to installation.
(See
Chapter 4
for more about configuration options.)
Figure 3-1. The internal DIP switches.
To set the DIP switches in an SFOM-HS2:
1. Use a small screwdriver to gently pry open each
of the unit’s four locking tabs and open the
plastic case (see
Figure 3-2
on the next page).
ON
ON
1
ON
2 3 4 5 6
7 8 9 10
Number of Bits (async)
Stop Bit (async)
Data Rate
Transmit Timing
Carrier
Loop Control
Summary of Contents for MT632A-SM23
Page 27: ...NOTES...
