Manual of VDSL2 Solution
http://www.black-box.eu
_____________________________________________________________________________
As you can see the Receiver offers you more options to configure. This is because you
can use the Receiver as an ADSL2+ Modem to be used with your incoming Internet
Service Provider Line as well as a point to point solution. Since the purpose of this
manual is to describe setup for your VDSL2 link
please leave the options for
WAN/NAT/Firewall/Route and uPnP unchanged
!
SYSTEM
Administator Settings (Transmitter and Receiver)
Allows you to change the default password
Firmware Upgrade (Transmitter and Receiver)
Allows you to upgrade the firmware
Device Mode (Receiver only)
Allows you to change the Receiver from VDSL2 Extender Set to ADSL2+ Router. Leave
setting to Switch Mode for normal operation
(Switch Mode in Factory Default)
System Status
Information about the Device
Reboot
Lets you reboot the Device while leaving the settings unchanged
Reset System
Lets you reboot the Device while setting everything back to factory default
LAN
LAN Settings
Lets you configure IP Address and enable or disable the DHCP Server
(Disabled in Factory Default)
DHCP Client List
Lets you view the IP Addresses given to network devices by the DHCP Server
LAN Switch Port Setting
Lets you configure which Speed and Duplex Mode ALL 4 SWITCH PORTS do.
(Auto 10/100 Full/Half in Factory Default)
LAN Port Status
Lets you view the status of the four Switch Ports.
