Manual of VDSL2 Mini MEG101AE-R4
Page #8
http://www.black-box.eu
_____________________________________________________________________________
Installing the Modem MEG101AE-R4
Hardware Installation
MEG101AE-R4 can be used for any indoor, dry and well temperatured environment.
Watch out to not exceed the temperature range. This may also be possible by stapling the
MEG101AE-R4 which is not allowed and should not be considered.
The Modem should be located in a cool dry place, with at least 10cm/4in of space
at the front and back for ventilation.
Place the Modem out of direct sunlight, and away from heat sources or areas with
a high amount of electromagnetic interference.
Check if network cables and connectors needed for installation are available
Avoid to use any telephony ribbon cables.
Avoid to use any low diameter cables.
Recommended is at least AWG26, better AWG24.
MEG101AE-R4 is not capable of doing PoE PSE or PD. You may connect PoE
devices, but they will not be powered.
Read page 4 for setup steps.
Front Panel Description:
The front panel shows from left to right:
LAN1/LAN2 Port
Network Ports 10/100Mbps, RJ45, Autonegotation
LAN1/LAN2 LED
Off if no link, On if link and flashing while transferring data
LINE LED
Off if no link, On if linked, Flashing slowly if just
synchronizing, flashing fast if transferring data.
LINE Port
2 Wire VDSL2 Connection. Use either RJ11 (middle pins) or
Terminal Block, never both. You can use RJ11 on
Transmitter and Terminal Block on Receiver side
PWR LED
Off if unpowered, On if powered
TM LED
On if running in Transmitter mode
RCV LED
On if running in Receiver mode
