19
CHAPTER 3: Installation
NOTE
On a PC, use a program such as Sniffer to conduct the
tests. Other methods include the use of SmartBits series
testing equipment. If you don’t have access to either
method, call Technical Support.
3.2 Installing the Converter
Once you’ve set your converter as described in
Section
3.1
, you’ll need to place it on a desktop or mount it on a
wall. Next, power on the converter. Connect the
converter to a 10/100BASE-TX device or network
segment. Finally, connect the converter to a 100BASE-
FX device or to another media converter via fiberoptic
cable. Follow the steps listed below:
1. For desktop installation, affix the four non-skid
rubber feet to the bottom of the converter.
For wallmount installation, use the underside of
the converter as a template to measure and mark
out the position of the holes onto the surface
where you will install the converter. Then use the
two mounting screws provided to mount the
converter firmly in place.
2. Connect the appropriate power supply for your
country to the power connector on the side of the
Summary of Contents for LH1706A-SC-AU
Page 2: ......