37
CHAPTER 4: Web-Based Management
Table 4-11 (continued). Advanced or Simple Mode parameters.
Parameter
Description
Advance or Simple buttons
Click on this button to go to the Advanced or Simple Mode screen.
Apply button
Click on this button to Apply the selections.
In Advanced mode, some additional options are available. Refer to the bottom portion of the screen shown in
Figure 4-16 and see Table 4-12.
Table 4-12. Advanced Mode Only parameters.
Parameter
Description
Special TCP/UDP class
Select Low or High priority from the drop-down menu.
Default class (all other TCP/UDP ports)
Select Low or High priority from the drop-down menu.
Port
From the drop-down menu, select port 1–24 to enable the
special function to work on the selected ports. Select the
All
option to set up all ports at the same time.
Custom
Type in the number of the Special TCP/UDP port you
want to select.
Apply button
Click on this button to apply the selections.
If you click on the
Simple
button in Figure 4-16, you’ll return to the screen shown in Figure 4-15 and all L4 port
numbers will disappear.
IP Diffserv Classification (see Figure 4-12)
This option is not currently used.
4.2.9 B
ANDWIDTH
M
ANAGEMENT
The Bandwidth Management function is used to set up the limit of Ingress and Egress bandwidth for each port.
NOTE
Each switch port owns 16 KB packet buffer. The packet buffer size will be reduced
when the bandwidth rate limitation is enabled, which may cause a frame to not be
forwarded.
Figure 4-17 shows the Bandwidth Management Configuration. To get to this screen, click on
Bandwidth
Management
in the Configuration menu on the Home screen.
Summary of Contents for LGB2003A
Page 3: ......
