78
ETHERNET PRINT SERVERS HIGH SPEED AND 4-PORT
Fig. 5-7. Printer Setup.
Protocol Setup
Protocol Setup is used to set up the protocols on the unit when you do not
have access to a Novell NetWare server or workstation and/or when TCP/IP
users do not have access to a rarp server.
Ethernet Print Server users are limited to 2 protocols. Be sure to turn off
protocols that you are not going to use. TCP/IP users also must enter the IP
address, Subnet Mask, and Default Gateway.
TCP/IP Users
If the Ethernet Print Server does not have an IP address and Subnet Mask
established when you bring up this screen, the information in the IP address
and Subnet Mask fields will be incorrect. You must enter the correct IP
address and Subnet Mask values now. If you supply erroneous values, TCP/IP
will not be enabled and you will not be alerted by an error message.
Port
number
1
2
3
Uniport
Printer Setup
Ethernet Print Server #123456 1
This Port Not Available
This Port Not Available
This Port Not Available
Cancel
OK
PostScript
Yes No
Port Number identifies the
Ethernet Print Server port.
Only port 1 (MIO) is usable.
PostScript identifies wether the
printer connected to the port is
PostScript or not. If the printer is
PostScript, YES is chosen. Only
PostScript printers will appear in
Chooser. Non-PostScript printers
cannot be used by AppleTalk
users.
Printer Name is the name assigned
to the Ethernet Print Server printer.
If there is no entry or if you want to
change the name, then click on the
box and type in the printer name.
Click on OK when you are done
viewing the configuration or
making changes to it.
The Ethernet Print Server attached printer will
appear as shown above. You can change the
name if you want to. The name shown above
contains the Ethernet Print Server serial number.
Printer Name
