15
CHAPTER 3: Installation
3.3 Installing the Converter
After you set the MDI/MDI-X button as described in
Section 3.1
and determine how you will use your
converter as shown in
Section 3.2
, you’ll need to place
the converter on a desktop or mount it on a wall. Next,
power on the converter. Connect the converter to a
10BASE-T device or network segment. Finally, connect
the converter to a 10BASE2 Ethernet device or to
another media converter via ThinNet coaxial cable.
Follow the steps listed below:
1. For desktop installation, affix the four non-skid
rubber feet to the bottom of the converter.
For wallmount installation, use the underside of
the converter as a template to measure and mark
out the position of the holes onto the surface
where you will install the converter. Then use the
two mounting screws provided to mount the
converter firmly in place.
2. Connect the appropriate power supply for your
country to the power connector on the side of the
converter. Plug the power supply into a suitable
power outlet.
Summary of Contents for LE1604A-AU
Page 3: ......
