Express Ethernet Switch
LED
State
Indication
LNK (link)
Steady
The port has established a valid network connection
ACT (activity)
Flashing
The port is transmitting or receiving data
FDX (full-duplex)
Steady
The connection is in full-duplex mode
Off
The connection is in half-duplex mode
Uplink button
Optional fiber module for LB9017A-R2 & LB9024A
Refer to the following Special Features section for installation instructions.
Special features for LB9007A-ST-R2, LB9007A-SC-R2, LB9012A-R2, LB9017A & LB9024A
LB9007A-ST-R2, LB9007A-SC-R2, LB9012A-R2, LB9017A & LB9024A house a console port that enables
connection to establish a VLAN (virtual local area network), port aggregation, the setting of half or full-duplex
transmission, and the setting of 10Mbps or 100Mbps for TX transmission.
For these features to operate through the console port, it is necessary to first configure in DOS or a terminal
emulation program such as HyperTerminal.
Setting up Console Port Connection
To configure these features through the console port, it is necessary to first configure a terminal emulation program
in DOS or in Windows such as HyperTerminal.
•
Check the switch, cables, and computers for proper installation before configuration.
•
Attach a PC or any VT100 compatible terminal to the console port on the back of the switch (see figure 6)
using the following settings:
Terminal type
VT100
Port type
(COM 1~4)
Communication Mode
8 data bits, 1 stop bit, no parity and 9600bps (for initial configuration)
Flow Control
None
Hardware
Compression
NA
23
