1000 Park Drive • Lawrence, PA 15055-1018 • 877-877-2269 • Fax 724-746-0746
© Copyright 2019. Black Box Corporation. All rights reserved.
TRADEMARKS USED IN THIS MANUAL
Black Box and the Double Diamond logo are registered trademarks of
BB Technologies, Inc.
Kevlar is a registered trademark of E.I. du Pont de Nemours and Company.
Any other trademarks mentioned in this manual are acknowledged to be the property of the
trademark owners.
5. Secure the cable to the cable tie bracket as shown in Figure 1.
NOTE: Do not over-tighten the cable ties!
Grid label
Cable ties
Cabinet
assembly
Place danger
label here
Cable
management
clips
Figure 1. Inside view of the cabinet.
6. Loosely route fibers around the fiber management clips to determine the best
length for terminating and storing the fiber slack. Trim the fibers, if necessary,
and remove the excess from the clips.
7. Terminate the fibers according to the connector manufacturer’s
recommendations.
NOTE: The installer must determine the proper termination method, including whether
additional supportive materials (break-out kits) are required.
8. When all fibers are terminated, clean the connectors and insert them into the
appropriate adapters.
9. Gently route the fiber slack into the management clips.
jpm403a-r2_user_rev2.pdf
