Passive CCTV Hub Installation Guide
Page 14
Port Switch Settings:
4.
For each camera port, determine whether video, power and/or control is to be
transmitted via the same Cat5 cable. If only video is to be transmitted, then the
Power/Control terminals and port switch may be disregarded.
5.
In order to transmit video on one (1) twisted pair, remote power on two (2)
twisted pairs and control on one (1) twisted pair, set the port switch to Pass-
Thru Mode (IC452A) as shown in figure 13. Ensure that there is a CCTV
Pass-Thru Balun (IC452A) at the camera.
Figure 13: Port Setting – Pass-Thru Mode (IC452A)
6.
In order to transmit video on one (1) twisted pair and remote power on three (3)
twisted pairs, set the port switch to Power-Thru Mode (IC560A/IC561A) as
shown in figure 14. Ensure that there is a CCTV Power-Thru Balun (IC560A or
IC561A) at the camera.
Figure 14: Port Setting – Power-Thru Mode (IC560A/IC561A)
