Page 22
724-746-5500 | blackbox.com
Chapter 4: Control Modes
Command
Function
Feedback Example
ON[X][Y1],[Y2],[Y3]. Switch on several outputs of a trans-
mitter;
[X]: unit ID, varies from 00–15;
[Y]: serial number of output port, the
value can be 1–5 (1 corresponds to the
HDMI output port, 2~5 correspond to
HDB OUT 1–4 separately.)
On Y1, Y2, Y3
Y=1–5
ON[X][0].
Switch on all outputs of a transmitter;
[X]: unit ID, ranges from 00–15.
On All
NOTES:
1. In the above commands, “[”and “]” are symbols for easy reading and do not need to
be typed in actual operation.
2. Type in the complete commands including the ending symbol “.”.
3. When the unit ID is changed, reboot the unit before sending commands.
4. To control a third-party device via RS-232 commands, type in the correct serial num-
ber for the device’s baud rate in the command. The table on the next page shows a
list of the baud rates and their serial numbers.
Table 4-2. Baud rates and serial numbers.
Baud Rate Serial Number
2400
1
4800
2
9600
3
19200
4
38400
5
57600
6
115200
7
