12
NETWORK VIDEO CODEC
3.4 LAN/WAN Settings
To allow you to view video from Codecs connected to other network segments,
you need to tell the system about those networks.
To do this, you need to know the following information about the other
networks.
• Network IP Address. This needs to include the Network Number and, if using
subnets, then the Subnet Number (that is, everything excluding the Host
Number). The Network IP Address does not need to be the actual IP address
of a Codec on the network, but any valid Codec IP address will suffice, since it
will contain both the Network Number and Subnet Number.
• Network Subnet Mask
These step-by-step instructions explain how to add up to four additional
network segments.
1. Select the Setup Web page and then select the LAN/WAN Web page.
2. Enter the IP Address and Subnet Mask for each network in the corresponding
boxes.
3. Enter a time in seconds in the Maximum Network Response Time box. This
time is used to tell the system how long to scan for Codecs. The default time
is 3 seconds. This value should always be the minimum possible, since it is not
possible to view video until the scan is complete.
4. Upon leaving this page, the information will be stored.
NOTE
When the networks you want to scan are further away from your local
network, you may need to increase the maximum network response
time.
