Switching and filtering is performed at wirespeed: 148810 packets/second
The MXU9020 can handle a traffic level of 4064 packets/second over the E1 link.
The MXU9020 should not be connected to cabling which would be required by BS6701 to be
equipped with over-voltage protection. The following ports are designated SELV (Safety
Extra Low Voltage) within the scope of EN41003:
E1 Line (or WAN) port (BNC or RJ45)
4 x 10/100BASE-T Ethernet ports
These ports should only be connected to SELV ports on other equipment in accordance with
EN60950 clause 2.3.
In order to ensure EMC compliance all signal and data cables and connectors must use a
screened connector shell with a screened cable. The cable screen must be terminated to the
screened connector shell and not connected to any pins of the connector. Failure to use the
correct connector may compromise EMC compliance.
The MXU9020 is a Class A product. In a domestic environment it may cause radio
interference in which case the user may be required to take adequate measures.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commerical
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the isntruction manual, may cause harmful
interference to radiocommunications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at their own expense.
Abeo LAN over G.703 Extender
3
1.2 Performance
1.3 Safety
1.4 Electromagnetic Compatibility
1.5 EN55022 Declaration
1.6 FCC Declaration
Summary of Contents for Abeo G.703 LAN
Page 18: ......
