WARNING:
This product or its power cord contains lead, a chemical known to the State
of California to cause cancer and birth defect or other reproductive harm. Wash hands
after handling.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK:
• NEVER immerse the unit in water or any other liquid, or use when wet.
• Do not insert foreign objects into the DC outlet.
WARNING: TO REDUCE THE RISK OF FIRE:
• Do not operate near flammable materials, fumes or gases.
• DO NOT expose to extreme heat or flames.
CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
• Remove appliance plug from outlet before working on the appliance.
• ALWAYS turn the converter OFF by disconnecting it from the AC outlet when not in use.
• Do not open the converter — there are no user-serviceable parts inside.
• Do not use this converter with medical devices. It is not tested for medical
applications.
• Only use to operate 12 volt DC devices that are equipped with a power cord rated at a
minimum of #18 AWG copper.
• Make sure the12 volt DC appliance plug is wired correctly. The 12 volt DC socket is
wired so the center conductor is positive (+) and the shell conductor is negative (–).
• Keep away from children. This is not a toy!
• Install and operate unit only as described in this Instruction Manual.
• Do not use this converter on a watercraft. It is not qualified for marine applications.
• Check unit periodically for wear and tear. Take to a qualified technician for
replacement of worn or defective parts immediately.
• Read And Understand This Instruction Manual Before Using This Unit.
SAVE THESE INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY OR PROPERY DAMAGE:
Follow these instructions and those published by the manufacturer of any equipment
you intend to use with this unit. Review cautionary markings on these products.
INTRODUCTION
Thank you for purchasing the
Black & Decker
®
Traevl Mate
TM
AC/DC Converter.
It is
useful for a wide variety of applications including: Operating and charging cell phones
and automotive accessories requiring less than 6 amps of 12 volt DC current. This
includes 12 volt DC operated thermoelectric cooler/warmers, spotlights to 70 watt bulb
rating, portable air ionizers, and charging jumpstarters.
• PROPER COOLING
is essential when operating the converter. Do not place the unit
near a heat vent or in direct sunlight. Do not block ventilation slots.
• GROUND FAULT CIRCUIT INTERRUPTER (GFCI)
protection should be provided on
the circuits or outlets to be used. Receptacles are available having built-in GFCI
protection and may be used for this measure of safety.
• USE OF ACCESSORIES AND ATTACHMENTS.
The use of any accessory or
attachment not recommended for use with this appliance could be hazardous.
Note:
Refer to the “Accessories” section of this manual for further details.
• CHECK DAMAGED PARTS.
Before further use of the appliance, a guard or other part
that is damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated elsewhere in this
instruction manual. Have defective switches replaced by authorized service center. Do
not use tool if switch does not turn it ON and OFF.
• OUTDOOR USE EXTENSION CORDS.
When tool is used outdoors, use only extension
cords intended for use outdoors and so marked.
• EXTENSION CORDS.
Make sure your extension cord is in good condition. When
using an extension cord, be sure to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The following table shows the correct size to use
depending on cord length and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the cord.
Minimum Ga
g
e for Cord Set
s
Volt
s
Total
Len
g
th of Cord in Feet
120V
0-25
26-50
51-100
101-150
(0-7,6m)
(7,6-15,2m)
(15,2-30,4m)
(30,4-45,7m)
240V
0-50
51-100
101-200
201-300
(0-15,2m)
(15,2-30,4m)
(30,4-60,9m)
(60,9-91,4m)
Ampere Ratin
g
More
Not more
American Wire Gage
Than
Than
0 -
6
18
16
16
14
6 -
10
18
16
14
12
10 -
12
16
16
14
12
12 -
16
14
12
Not Recommended
SAFETY GUIDELINES / DEFINITIONS
DANGER:
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates potentially hazardous
situation which, if not avoided, may result in property damage.
RISK OF UNSAFE OPERATION.
When using tools or equipment, basic safety
precautions should always be followed to reduce the risk of personal injury. Improper
operation, maintenance or modification of tools or equipment could result in serious
injury and property damage. There are certain applications for which tools and
equipment are designed. Black & Decker strongly recommends that this product NOT
be modified and/or used for any application other than for which it was designed. Read
and understand all warnings and operating instructions before using any tool or
equipment.
IMPORTANT SAFETY INSTRUCTIONS
GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL APPLIANCES
READ ALL INSTRUCTIONS
WARNING:
Read all instructions before operating product. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury.
• AVOID DANGEROUS ENVIRONMENTS.
Don’t use appliances in damp or wet
locations. USE THE UNIT INDOORS ONLY.
• STORE IDLE APPLIANCES INDOORS.
When not in use, appliances should be stored
indoors in dry, and high or locked-up place – out of reach of children.
• DON’T FORCE APPLIANCE.
It will do the job better and with less likelihood of a risk
of injury at the rate for which it was designed.
• USE RIGHT APPLIANCE.
Do not use the appliance for any job except that for which it
is intended.
• DON’T ABUSE CORD.
Never carry appliance by cord or yank it to disconnect from
receptacle. Keep cord from heat, oil, and sharp edges.
• DISCONNECT APPLIANCES.
Disconnect the appliance from the power supply when
not in use, before servicing, and when changing accessories such as blades and the
like.
CV6B ManualEN 022708.qxp 2/27/2008 5:01 PM Page 4
