6
7
FILTER
We recommend that you remove and clean the filter every 6 uses depending on the
water hardness in your area. The warning light/reset button will flash to remind you that
the filter needs cleaning. Doing this will extend the life of the unit.
To remove the filter:
1.
Unplug the appliance and let it cool down.
2.
Allow your steam generator to cool down for at least 1 hour
until the soleplate is cold.
3. Remove the reservoir from the front of the unit. The filter is behind the reservoir.
4. Turn the filter anticlockwise and remove it (Fig B).
5. Rinse the filter under a tap.
6. Refit the filter and tighten it firmly.
7. Reset the reminder light.
AFTER USE
1.
Put the iron on top of the base unit and turn the temperature control to (
•
)
.
2. Turn the unit off by setting the on/off button to
O
.
3. Empty the reservoir.
4. Let the iron cool down completely before cleaning it, moving it, or storing it
away.
5. The steam pipe can be coiled together and placed into the hose clip.
6. Wrap the mains cable around the steam generator in an anti-clockwise direction
then slot the plug into the socket (Fig C).
7. The water reservoir must be emptied when storing your steam station vertically.
CARE AND MAINTENANCE
1.
Unplug the base unit, and let the appliance cool down fully.
2. Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up
liquid.
3. Remove spots from the soleplate with a little vinegar.
4. Take care not to scratch the soleplate
ANTI-SCALE CARTRIDGE
To extend the life of the appliance and to avoid problems with lime scale, your steam
generator is fitted with an anti-scale cartridge. The life of the anti-scale cartridge
depends on the frequency of use and the hardness of the water in your area.
In a soft water area this should be about 100 uses. Do not put any descaling
products (including vinegar) into the reservoir. This can damage the appliance.
To replace the cartridge:
1.
Switch off and unplug your steam generator
2. Allow your steam generator to cool down for at least 1 hour
until the soleplate is cold.
3. Remove the water tank from the front of the unit.
4. Pull the anti scale cartridge vertically out of the water tank.
Note that the cartridge may contain water when it is removed (Fig A).
5. Fit the new cartridge and push it down firmly into the water tank.
6. Refill and refit the water tank.
7. Plug in your steam generator.
8. Once the appliance is ready, pull the steam trigger until the steam is being
produced. This will prime the system.
Important: Using the appliance without changing the cartridge can cause a reduction
in the generated steam output and damage the appliance. The guarantee will not
cover damage caused to the appliance by not changing the anti- scale cartridge
when required.
