5. Locate the edge guide and spread it apart as shown in
figure 3
.
6. Attach the edge guide to the housing by locating the two ends
into the holes in the housing.
7. See figure 3A for edge guide assembled on the trimmer.
DO NOT INSERT THE ENDS OF THE EDGE GUIIDE INTO THE
FAN HOLES AS SHOWN IN FIGURE 3B.
8. Remove the guard attachment screw
from the guard. Slip the guard onto
the trimmer housing and lineup the
screw hole in the guard with the
screw hole in the housing
(figure 4)
.
9. Insert the guard attachment screw to
secure the guard in place as shown in
figure 5
.
10.Attach extension cord
to cord retainer as
shown in
figures 6 & 6A
.
OPERATING INSTRuCTIONS
AuTO fEED SySTEm
Your trimmer uses .065 in. (1.65 mm) diameter,
ROuND
nylon line
to cut grass and weeds quickly and easily. During use, the tip of the
nylon line will become frayed and worn and the special self feeding
line hub will automatically feed and trim a fresh length of line.
Cutting line will wear faster and require more feeding if the cutting
or edging is done along sidewalks or other abrasive surfaces or
heavier weeds are being cut. The advanced automatic line feeding
mechanism senses when more cutting line is needed and feeds
and trims the correct length of line whenever its required. DO NOT
BUMP unit on ground in attempt to feed line
or for any other purposes.
CAuTION:
ALwAyS uSE EyE
PROTECTION.
CAuTION:
Inspect area to be trimmed
and remove any wire, cord, or string-like
objects which could become entangled in
the rotating line or spool. Be particularly
careful to avoid any wire which might be
bent outwardly into the path of the tool, such
as barbs at the base of a chain link fence.
1. Maintain a cutting angle of 5° to 10° as shown
in
figure 7
. Do not exceed 10°
(figure 7A)
.
Cut with the tip of the line. To keep distance
from hard surfaces use edge guide.
5
3A
3B
3
5
4
6
6A
5
O
-10
O
5
O
-10
O
7A
7
